It’s seems as if the butterflies are everywhere this month. I have enjoyed watching swallowtails moving through the back yard on light breezes. So today’s fiber object is inspired by a butterfly wing, specifically, a Monarch butterfly. It is also a chance for me to try out a new tool I recently acquired.
This set is produced by Honeysew. The large tape maker is by Clover. I purchased both through Amazon. They can make yards and yards of bias tape from any woven fabric, with the use of a hot iron. For this project I chose 1/2 inch tape maker.
The first step is to cut 1 inch strips of fabric on the bias, and seam them together with a very narrow seam allowance. After trimming the seam allowances, the fabric is fed through the wide end of the maker and pressed as it appears out of the narrow end.
Now that I have my tape, I will need fabric………..
And a plan. Here is a quick sketch of an abstract wing.
I made a photocopy of the sketch, cut out the major areas into pieces, and pinned and cut the fabric. Next I stuck the shapes onto my background fabric with a glue stick.
Starting at the top, I sewed the bias tape around the outside edge. When sewing down bias tape, it is important to sew the inside (convex) edge of your design first, being careful not to stretch the tape. Next, press the fabric and tape, smoothing out the outside (concave) edge. Then, stretching it as needed, stitch down the outside. I continued sewing the bias tape until all raw edges were covered. I also sewed a few bits of tape onto other major design lines. Here is the piece at the end of this step.
To emulate the lower edge of the Monarch wing, I cut a piece of dark gray fabric, drew the white spots across it, and then trimmed holes where each spot was. To make the spots white, I inserted a piece of white fabric behind the gray, gluing it in place with glue stick and fusible webbing. Here is the back side of this piece.
This was then stitched across the bottom edge of the piece and top stitched with a decorative stitch.
Finally, I used zig-zag stitch to add the small veins found throughout the wing.
Now that it’s done, I’m not quite sure how to use this particular piece. But I’m confident that the bias tape maker will come in handy for many a future appliqued design. How about stitching up a stained glass window?